A Candy Stripe Friendship Bracelet
#v12946
This stripy friendship bracelet is braided using the Candy Stripe method which consists of lots of small knots. You may vary the colours and the patterns at will.
#v12946
1. 
Cut three pieces of cotton cord, each measuring approx. 3m. Double over and tie a knot at the top, leaving a loop.
Cut three pieces of cotton cord, each measuring approx. 3m. Double over and tie a knot at the top, leaving a loop.2. 
Attach the cords; i.e. the loop at the top of the cords to a clip board and spread out the cords.
Attach the cords; i.e. the loop at the top of the cords to a clip board and spread out the cords.3. 
Place the outer right cord over the lace next to it, feed it underneath the loop and pull.
Place the outer right cord over the lace next to it, feed it underneath the loop and pull.4. 
Tie another knot and pull.
Tie another knot and pull.5. 
Place the outer left cord over the cord next to it, feed it underneath the loop and pull. Tie two knots following the described procedure.
Place the outer left cord over the cord next to it, feed it underneath the loop and pull. Tie two knots following the described procedure.6. 
Continue like this until two knots are made on all the cords.
Continue like this until two knots are made on all the cords.7. 
Repeat with the outer right cord moving towards the left, tie two knots etc.
Repeat with the outer right cord moving towards the left, tie two knots etc.8. 
-
-9. 
Tie two knots to the two outer cords on the right and on the left side, creating a fairly straight edge in both sides.
Tie two knots to the two outer cords on the right and on the left side, creating a fairly straight edge in both sides.10. 
Arrange the cords in pairs and plait.
Arrange the cords in pairs and plait.11. 
Bend over the finished plait and tie a knot, creating a loop.
Bend over the finished plait and tie a knot, creating a loop.12. 
Glue the end safely in place. This loop becomes part of the bracelet's fastener.
Glue the end safely in place. This loop becomes part of the bracelet's fastener.13. 
Cut off the excess cords.
Cut off the excess cords.14. 
At the other end tie a couple of knots on top of each other. Together they form the knot (button) to be used for fastening the bracelet in the loop at the other end.
At the other end tie a couple of knots on top of each other. Together they form the knot (button) to be used for fastening the bracelet in the loop at the other end.Close up 
-
-Close up 
-
-Guía paso a paso gratuita
Suscríbete a nuestro boletín y accede a esta idea creativa, además de recibir inspiración, novedades y fantásticas ofertas directamente en tu bandeja de entrada. Puedes darte de baja en cualquier momento.
¿Ya estás suscrito? Ver la guía
Lea nuestra Política de privacidad
También vete a explorar
